How to inject steroids in quad

The ‘Two-Pin’ technique increases sanitation for multiple dose vial users. They draw with the first pin, and then shoot/inject into the body with a new one. This procedure prevents any residual contaminants that may have remained on the drawing pin from being transferred into the body via the injection site. It also makes injection less painful since the drawing needle is necessarily dulled during passage through the rubber stopper atop the vial. A dulled needle increases injection pain because it doesn’t pierce the body as cleanly as an unused one. The protocol below is followed by AAS users who draw from multiple dose vials, but steps 4 - 8 are routinely disregarded by those users who draw from ampoules (also called ampules) and sachets.

First things first. Sterility. Only use new pins and do not share, do not let the pins make contact with anything that may be hazardous by keeping the plastic covering on when not being used, use substances which you are sure are legit, reputable, and are sterile, wash hands thoroughly before any procedures, inject in a clean sterile environment, and make sure the injection site is cleaned with antibacterial agents before and after administration. It’s easy to just skip this paragraph or become lazy over time, thinking that you will be fine. If you want to reduce your risk of infections (which can be very painful and put you out of training for a while), then always think about sterility before and after administration. Be smart.

How to inject steroids in quad

how to inject steroids in quad

Media:

how to inject steroids in quadhow to inject steroids in quadhow to inject steroids in quadhow to inject steroids in quadhow to inject steroids in quad

http://buy-steroids.org